Skip to main content

Generate a corridor

Modified: 22 Oct 2026 Quantm Help

In review mode, you can create avoid zones from the current alignment.

By defining left and right margins from the centerline of the alignment, you can create:
  • A corridor from two avoid zones, one on each side of the alignment at distances specified by left and right margins. This confines searches to the defined corridor:

    Map showing a corridor defined by avoid zones on both sides of the alignment.

  • An exclusion zone that covers the alignment with a left and right margin from a specified centerline:

    Map showing an exclusion zone along the alignment between the start and finish points.

  1. On the Optimization tab, select Generate Corridor.

    The Generate Corridor dialog appears.

  2. Select the required option, specify the margins, and click OK. The margins must be greater than 0.0 m.
    Note:

    You can change the nature of a corridor zone after you create it.

    Tip:

    To create a single avoid zone to one side of the alignment, create a corridor and then delete one of the avoid zones.

Submit

Table of Contents