Skip to main content

Create openings in Revit

Modified: 25 Jun 2026 Stabicad
Stabicad
Stabicad

Generate structural voids in Revit by placing openings manually, using element selections, or leveraging native interference check reports.

You can create openings in Revit with the following methods:

  • From a selection - Choose the MEP elements to create openings for.
  • Manually - Place openings manually in your project.
  • Using an interference check file - Place openings automatically in all locations where MEP categories and structural categories intersect.

Create openings from a selection in Revit

To create openings from a selection:
  1. Configure your default opening parameters in the Opening Settings (see Opening settings).

    Specify the following before generating openings:

    • Define required margins around MEP elements.
    • Set the minimum distance allowed between individual openings.
    • Enable the option to use linked models if your structural or MEP elements reside in external files.
  2. Select the MEP elements for which you want to generate openings.

    You can select elements from the current active model or from a linked model.

  3. Select the corresponding structural elements, such as walls or floor slabs.
Stabicad now automatically creates openings at every location where the selected MEP and structural elements intersect.

Create openings manually in Revit

To manually insert openings:
  1. Select the manual opening tool from the Openings menu.
  2. In the Properties palette, select the type of opening to place:
    • Choose a face-based opening to host it directly to a wall, floor, or ceiling.
    • Choose a non-hosted opening for independent placement.
  3. Configure the following properties before clicking to place the opening:
    • Shape - For example, rectangular, round
    • Dimensions - Width, height, or diameter
    • Elevation - Height from the active level
  4. Click the location in the drawing area to place the opening.
Stabicad now places the manual opening with the specified properties and adds it to the project's openings list.

Create openings based on interference check file in Revit

With a Revit interference report (HTML), you can generate openings for all detected clashes between MEP and structural categories in a single operation. This process automatically applies your predefined project settings.
  1. Run a native Revit Interference Check to identify intersections between MEP and structural elements.

    You can also access this functionality directly from the Openings Monitor.

  2. Export the results as an HTML file.
  3. In Stabicad, load the exported interference check file.
  4. Review the generated openings to ensure they align with project requirements.

    The application automatically calculates opening sizes based on your Opening Settings, specifically taking into account:

    • Margins defined for each element category.
    • Minimum distances required between adjacent openings.
Stabicad now places openings at every intersection identified in the interference report throughout the entire model.

Opening settings

Default Margins

You can define unique Margins for different MEP categories. These values are automatically added to the dimensions of the MEP element when openings are created from a selection or an interference check file.

  • Pipes
  • Ducts
  • Cable trays
  • Conduits

Default Distances and Geometry

The software uses distance settings to determine how openings are grouped and shaped:

  • Minimum distance between openings on the same host: Determines automatic merging. If the distance between two openings is smaller than this value, they are combined into a single rectangular opening.
  • Round diameter of round openings: Specifies predefined diameters. Openings smaller than these values are automatically rounded up to the nearest diameter in the list.
  • Maximum diameter for round openings: Sets the threshold for shape changes. If a round MEP element requires an opening larger than this value, a rectangular opening is placed instead.
Submit

Table of Contents