Skip to main content

Insert special sanitary appliances

Modified: 13 Apr 2026 Stabicad
Stabicad
Stabicad

Establish vertical transitions and manual fittings within a waste water system to connect multi-story sewerage installations.

While Stabicad automates many standard plumbing connections, complex multi-story waste water designs often require specific vertical transitions and manual component placement. By utilizing specialized tees, couplings, and stack connections, you can precisely link floor-level systems to main standpipes and maintain technical accuracy across different elevations.

Start a waste water system with a T-section

When drawing systems across multiple floors, floors are typically connected via a vertical standpipe. You link the floor-level system to this standpipe using a T-section as the primary connection point.

  1. Open the Waste Water palette, go to the Draw tab, and select Place tee.
  2. Specify the location on the standpipe where the T-section should be placed.
  3. In the Select [Element] dialog, select the appropriate component from the product line and click OK.
  4. If the T-section is not automatically snapped to a connection:

    In the New elevation dialog, enter the required elevation for the element and click OK.

  5. Indicate the rotation of the new T-section in the drawing.

    The T-section is inserted into the standpipe.

Once the T-section is placed, you can continue drawing the rest of the waste water system for that floor starting from the new connection point.

Place a connector manually

While Stabicad typically inserts connections automatically between pipes or ducts of the same diameter, you can use the manual placement function to select specific fittings or adjust rotations manually.

  1. Initiate the coupling function using one of the following methods:
    • Open the Sewerage palette, go to the Draw tab, and select Place coupling.
    • While actively drawing, right-click and select Fitting > Coupling.
  2. Select the conduit ending where the connector must be inserted.
  3. In the Select [Element] dialog, select the desired connection type from the list and click OK.
  4. Specify the rotation of the connector relative to the existing system.

After the connector is placed, you can continue drawing the system from the new fitting.

Insert a standpipe connection

Waste water systems on different floors are typically joined by a vertical standpipe. By placing a stack connection, you establish the vertical rise or drop necessary to continue the system on a different level.

  1. Open the Sewerage palette, go to the Draw tab, and select Place stack connection.
  2. Select the connection point on the existing pipe where the standpipe should begin.
  3. Specify the required length of the standpipe.
  4. Indicate the rotation of the standpipe relative to the system.

    The standpipe is inserted at the selected point.

Once the vertical stack is in place, you can proceed with drawing the horizontal system for the corresponding floor.

Submit

Table of Contents