Skip to main content

Configure the simultaneity factor

Modified: 10 Mar 2026 Stabicad
Stabicad
Stabicad

You can configure the simultaneity factor for power calculations to account for the probability that not all electrical loads will be active at the same time.

You can use the Manage Installation function to configure the simultaneity factor in both AutoCAD and Revit.

Set the simultaneity factor per symbol type

To set the simultaneity factor per symbol type:
  1. In the Manage Installation dialog, select the top-level installation node.
  2. In the details section (F3), see Simultaneity factor.
  3. To use the standard company values, click Retrieve.

    Stabicad fetches the default values defined in StabiBASE > Electrical Installation Engineering > Manage Installation > Simultaneity.

  4. Alternatively, manually enter the desired percentage factors for each symbol type in the list.
Stabicad now applies the simultaneity factors for the entire installation.

Set the simultaneity factor per circuit

To set the simultaneity factor at the circuit level:
  1. In the Manage Installation dialog, select a circuit.
  2. In the details section (F3), see Simultaneity factor.
  3. Configure the simultaneity factor.
    • To use a uniform factor, click Manual and enter a percentage. The value is applied to all electrical symbols on the circuit regardless of their type.
    • To use symbol-specific factors, click Standard. Stabicad calculates a unique simultaneity factor for each symbol type based on the defaults set in StabiBASE.
Submit

Table of Contents