Skip to main content

Preloaded family types for Revit

Modified: 26 Jun 2026 Stabicad
Stabicad
Stabicad

A guide to the essential base families included in the template that are required for software functionality and auto-routing.

The Stabicad template includes a minimal set of essential base families. These elements act as "seeds" that the software references to generate new types and systems automatically during the design process.

Important: Do not delete these base elements using the Purge Unused functionality. While these types are rarely placed directly in the model, they are necessary for the software to function. If you accidentally delete base elements, see Recover template content.

Cable Tray, Conduit, Duct, and Pipe Fittings

The template contains basic fittings for all MEP auto-routing components. These are used by native Revit auto-routing to construct initial systems. Once the layout is established, you can use Stabicad functionality to convert these generic fittings into specific manufacturer-checked products.

  • Auto-routing - Deleting these families may cause native Revit auto-routing to fail.
  • Conversion - These base types are required for the "Convert to Product" workflow.

Duct and Piping Systems

Basic duct and piping systems are provided for every system classification. These systems start with the S4Rx prefix. The software uses them as a basis to create new systems through the Project Setup tool or when inserting elements from the palettes.

Cable Trays, Ducts, Pipes, and Conduits

The template includes a limited number of basic types for primary containment and distribution categories. These serve as the foundation for creating new types as needed.

  • Conduits - Conduit types are pre-configured based on specific localized settings.
  • Minimalism - The number of preloaded types is kept to a minimum to keep the template lightweight and performant.

Install missing families

If Stabicad cannot find families, you need to manually download them from https://download.trimble.com/ and unzip them into the \Families subfolder of the installation directory.

For example:

%ProgramFiles%\Trimble\Stabicad
    [localization]\Families
Submit

Table of Contents