Skip to main content

Define portal frame tie geometry

Modified: 5 Mar 2026 Tekla Structural Designer 2025
2025
Tekla Structural Designer

You can activate ties in any span of the frame from the Ties page of the Portal Frame dialog box.

Add a tie

  1. Select the Ties page.
  2. Select Active to enable the tie to be defined.
  3. Pick the Type of tie that you require:
    • A Yielding tie is one that can only take tension. If it would go into compression Tekla Structural Designer handles the frame as though the tie does not exist. Such ties would usually have yielded at ultimate limit state, although this depends on the properties that you give them.

    • A Strut can take both tension and compression. If the tie goes into compression Tekla Structural Designer takes account of this in the design of the frame. If you use a strut you must ensure that the section that you use can carry the applied compressive force without buckling or yielding.

  4. Enter the Location of the tie.

    The diagrams below show the various locations in a standard span.

    Rafter tie

    Haunch end tie

    Eaves tie

    Haunch Underside tie

    Level tie

    Floor tie

  5. You need to enter the level for a Level tie. This must be at least 0.1 metres below the bottom of the lowest haunch and the same distance above the floor level (taken as 0.000 metres).
Submit

Table of Contents