Skip to main content

Diag brace connection (12)

Modified: 29 Oct 2025 Tekla Structures 2026
2026
Tekla Structures

Diag brace connection (12) connects a sag rod or a round bar to a rail. The connection creates bent connection plates bolted to the rail. The sag rod is threaded.

Objects created

  • Connection plates

  • Bolts

Use for

Situation Description

Sag rod connected to a rail with a bolted connection plate

Selection order

  1. Select the main part (rail).

  2. Select the secondary part (sag rod or round bar).

    To connect several secondary parts at the same time use area selection.

    The connection is created automatically when you select the seondary part.

Part identification key

Description

1

Connection plate

Picture tab

Use the Picture tab to define the connection dimensions.

Dimensions

Description

1

Connection plate dimension on the secondary part side

2

Secondary part dimension from the connection plate edge

3

Connection plate bolt edge distance

4

Connection plate dimension from the bolt center

5

Connection plate dimension on the main part side

Parts tab

Use the Parts tab to define the part properties.

Parts

Option

Description

Connection plates

Thickness and width of the connection plate

Option

Description

Default

Pos_No

Prefix and start number for the part position number.

Some components have a second row of fields where you can enter the assembly position number.

The default part start number is defined in the Components settings in File menu > Settings > Options.

Material

Material grade.

The default material is defined in the Part material box in the Components settings in File menu > Settings > Options.

Name

Name that is shown in drawings and reports.

Parameters tab

Use the Parameters tab to define the cut or hole created in the connection plate.

Cut or hole for sag rod in connection plate

Option Description

Creates a part cut in the connection plate.

The parts do not clash. The holes cannot be dimensioned in drawings. Tekla Structures does not check edge distances.

Creates a bolt hole in the connection plate.

Holes can be dimensioned in drawings.

Tolerance

Define the tolerance for the cut or hole created in the connection plate.

You can use the tolerance setting to make the cut or hole bigger than the actual profile size.

The minimum hole diameter is 10 mm, with a 0 mm tolerance. Tekla Structures does not check edge distances.

Bolts tab

Use the Bolts tab to define the bolt properties.

Bolt basic properties

Option

Description

Default

Bolt size

Bolt diameter.

Available sizes are defined in the bolt assembly catalog.

Bolt standard

Bolt standard to be used inside the component.

Available standards are defined in the bolt assembly catalog.

Tolerance

Gap between the bolt and the hole.

Thread in mat

Defines whether the thread may be within the bolted parts when bolts are used with a shaft.

This has no effect when full-threaded bolts are used.

Yes

Site/Workshop

Location where the bolts should be attached.

Site

Bolt assembly

The selected check boxes define which component objects (bolt, washers, and nuts) are used in the bolt assembly.

If you want to create a hole only, clear all the check boxes.

To modify the bolt assembly in an existing component, select the Effect in modify check box and click Modify.

Bolt length increase

Define how much the bolt length is increased. Use this option when, for example, painting requires the bolt length to be increased.

General tab

Click the link below to find out more:

General tab

Analysis tab

Click the link below to find out more:

Analysis tab

Submit

Table of Contents