Help

Hardboard and Roll-Up Digitizers

Modified: 7 Jun 2026 Viewpoint Estimating Administration Installation and Setup Estimating Help
Viewpoint offers both hardboard and roll-up digitizers from GTCO that make it easier to enter information into your application from a drawing or a blueprint.
Choose one of these supported digitizers:
  • GTCO Roll-Up III
  • GTCO Roll-Up II
  • GTCO Roll-Up
  • GTCO Super L VI
  • GTCO Super L IV
  • GTCO Super L III
  • GTCO Super L II+
  • GTCO Super L II

Other digitizers may function with your application. If you are unsure whether your digitizer is compliant, Contact Trimble Viewpoint Support.

Note: Do not install a digitizer and a touch screen monitor on the same workstation.

Complete the following steps to set up a digitizer for use with your application:

  1. Depending on your digitizer type, do one of the following:
  2. Install and configure the digitizer driver. See Installing and Configuring the Digitizer Driver.
  3. Locate the mouse pad and the menu pad. See Locate the mouse pad and menu pad.
Submit
Previous
Next