Adjust an annotation

  1. Open a job in the Manage Estimates screen.
  2. Click Select on the speedbar.
  3. Click on the annotation you want to adjust.
  4. Click on a control point (figure 2) of the annotation, and hold the mouse button.
  5. Drag the control point to the appropriate location and release the mouse button. The annotation’s shape has been modified. Notice that the quantity displayed in the NotePad tab and Active Notepad Line adjusts itself automatically.
    Note: If you didn't have the mouse over a control point while dragging, move the entire annotation moves.
  6. To add additional control points, right-click the portion of the annotation you want to place the control point on and select Add Control Point.
  7. Repeat steps 3 - 5 as needed, until all adjustments are complete.

    In the image above, Figure 1 shows a mistake made on an area. To correct this, select the annotation (shown in figure 2). The control points are visible on the annotation once it is selected. In this example, Figure 2 shows the lower corner of the area repaired by dragging the lower control point down until it was flush.