Skip to main content

Create a single column or series of columns

Modified: 12 Nov 2024 Tekla Structural Designer 2025
2025
Tekla Structural Designer

With Tekla Structural Designer, you can create various kinds of column. You can model columns in 2D views, frame views, and structure views.

Create columns in a level view

  1. Ensure that you have defined the construction levels between which the column will run and the grid points between which it will lie.
  2. Select the column type and size.
  3. In the Properties window , adjust the base level and top level of the column, and other column properties, if necessary.
  4. Either, click each point where you want to place a column
  5. Or, to create a series of columns
    1. Move the mouse pointer to one corner of an imaginary box that will encompass the grid intersection points where you want to create columns.
    2. Hold down the left mouse button.
    3. Drag the mouse pointer to the diametrically opposite corner of the box.
    4. Release the mouse button.
  6. Press Esc to finish creating columns.

Create a discontinuous column in a frame or structure view

Note:

In order to define a column in a frame view or a structure view, you must have already created the construction levels between which the column will run, and the grid points between which it will lie.

  1. Select the column type and size.
  2. In the Properties window ensure Continuous is unselected and other properties are set as required.
  3. Click the start point of the column.
  4. Click the end point of the column.

    Tekla Structural Designer creates the column between the selected points.

Create a continuous column in a frame or structure view

Note:

In order to define a column in a frame view or a structure view, you must have already created the construction levels between which the column will run, and the grid points between which it will lie.

  1. Select the column type and size.
  2. In the Properties window ensure Continuous is selected and other properties are set as required.
  3. Pick the start point.
  4. Pick the end point of stack 1.
  5. Pick the end point of stack 2.
  6. Continue picking points to add stacks.
  7. Pick the same point again to end the command.

    Tekla Structural Designer creates the column between the selected points.

Submit

Table of Contents