Skip to main content

Validation settings

Modified: 10 Nov 2021 Tekla Structural Designer 2026
2026
Tekla Structural Designer

The Home > Model Settings > Validation page allows you to control the checks that are applied when the current model is validated.

Item Description

Error limit for length

Allows you to control when an error is displayed when very short analysis elements are detected.

Warning limit for length

Allows you to control when a warning is displayed when very short analysis elements are detected.

Error limit for quality

Allows you to control when an error is displayed when poor quality 2D elements are detected.

Note:

2D element quality depends on two things: skew and aspect ratio. 0% is bad quality: a squashed triangle tends towards bad quality, whereas 100% is perfect quality, so an equilateral triangle is perfect quality.

Warning limit for quality

Allows you to control when a warning is displayed when poor quality 2D elements are detected.

Check for validation warnings

Allows you to specify which model, analysis, and design validation checks are performed. If a box is cleared, the validation check is not performed.

Submit

Table of Contents