Skip to main content

Defining Tees (105)

Tekla Structures 2021
2021
Tekla Structures

There are several ways to create the tees at the end of the braces:

  • On the Parts tab, specify a T profile to use.

  • On the Parts tab, specify an I profile to use. The component creates the tee by cutting the I profile. You must specify where to cut the I profile, using the Tee depth field on the Parameters tab.

  • To have Tekla Structures use two plates to create the tee, leave the Tee profile field on the Parts tab blank. You must enter t,b, and h dimensions for the tee flange and web.

Note:

You can define the Tees for each brace separately.

Submit

Table of Contents