Skip to main content

Profile conversion logic in IFC object conversion

Tekla Structures 2021
2021
Tekla Structures

It is possible to map an IFC part profile name with a Tekla Structures profile. If a profile is not mapped, Tekla Structures uses a certain logic in converting profiles in the IFC object conversion.

When a parametric profile is used in the IFC model, the I, L, U, C, T, Z, Rectangle and Circular type profiles can be defined parametrically:

  1. If the IFC file has been created with Tekla Structures, the original profile name is used.
  2. If a profile with the same name is found from the Tekla Structures profile catalog, that profile will be used.
  3. Otherwise, Tekla Structures checks the parameter values to find a corresponding profile. If found, that will be used.
  4. Otherwise, a default parametric profile is used.

When an arbitrary profile used in the IFC model, the profile shape is defined with polygon:

  1. If the IFC file has been created with Tekla Structures, the original profile name is used.
  2. If the shape is detected and found from Tekla Structures profile catalog, that profile will be used. The shape detection supports the standard types of hot rolled profiles.
  3. Otherwise, a new profile is created based on the description of the arbitrary profile.

When B-rep geometry used in the IFC model, the object is defined with surfaces, and profile geometry information is not available:

  1. If corresponding item exists in Tekla Structures model, it will be used.
  2. Otherwise, a new item will be created and used.

If Conversion as item is used for extrusion type of part, a new item is always created.

Submit

Table of Contents