Simulates the opening or closing of an inner portion of an angle profile by cutting and bending the profile.
Use this component to create detail drawings that indicate where to open or close angle profiles used in tower bracing. In the shop, the angle profile is machined, not cut.
Parts created
-
Use for
|
Situation |
More information |
|---|---|
|
|
|
|
|
Do not use for
To open or close one end of an angle profile, use Open/Close angle ends (1050).
Before you start
-
Create a point to locate the component
-
Set the work plane parallel to the outer face of the leg of the angle profile that you want to bend:
Defining properties
Use the following tabs in the component dialog box to define the properties of the component:
|
Tab |
Contents |
More information |
|---|---|---|
|
Parameters |
Which leg to open or close, location of cut, bend angle. |
Picking order
-
Angle profile
-
A point on the angle profile