After you have sketched a profile, use dimensions to make different distances in the profile parametric. You can use these dimensions to define the size of the profile when you use it in a model.
Tekla Structures also adds the dimensions you create to the list of variables that you can use in calculations.
Do not create too many dimensions in a sketch. If there are too many dimensions, the dimensions cannot adjust when the values are changed.
In this example, if you create the dimension marked in red, the dimension b1 no longer works:
Add a radial dimension to a sketch
You can create a radial dimension for an arc or a circle in a sketched profile.
Before you begin, sketch the outline of the profile in the sketch editor.
Add an angle dimension to a sketch
You can create an angle dimension between two lines in a sketched profile. The angle is calculated counter clockwise from the first line you select.
Before you begin, sketch the outline of the profile in the sketch editor.
Add a dimension between two points in a sketch
You can add a dimension to a sketched profile, between two points you pick.
Before you begin, sketch the outline of the profile in the sketch editor.
Add a horizontal dimension to a sketch
You can add a horizontal dimension to a sketched profile, between two points you pick.
Before you begin, sketch the outline of the profile in the sketch editor.
Add a vertical dimension to a sketch
You can add a vertical dimension to a sketched profile, between two points you pick.
Before you begin, sketch the outline of the profile in the sketch editor.
Delete a dimension from a sketch
If a dimension is no longer needed in a sketch, you can delete it.
.
.
.
.