Open/Close angle (1051) creates the opening or closing of the inner portion of an angle profile by cutting and bending the profile.
Use for
Use this component to create detail drawings that indicate where to open or close the angle profiles used in tower bracing. In the shop, the angle profile is fabricated, not cut.
| Example | Example |
|---|---|
|
|
|
To open or close one end of an angle profile, use the Open/Closer angle ends (1050) component.
Before you start
-
Create an angle profile.
-
Create a point to place the component.
-
Set the work plane parallel to the outer face of the leg of the angle profile that you want to bend.

Selection order
-
Select the angle profile.
-
Pick the point on the angle profile.
The component is created when you pick the point.
Parameters tab
Use the Parameters tab to define the location of the cut, bend angle, and which leg to open or close.
| Option | Description |
|---|---|
|
Length portion from insert point starting point of prof. |
The length is measured from the point you pick to create the component towards the start of the part reference line. |
|
Length portion from insert end point of prof. |
The length is measured from the point you pick to create the component towards the end of the part reference line. |
|
Angle of opening/closing |
Define the bend angle. |
|
Switch to define the leg to open/close |
Select the leg to open or close. |
General tab
Click the link below to find out more:
Analysis tab
Click the link below to find out more:

