Rolled cans (S21) creates tubular rolled can profiles between two selected points.
Objects created
-
Rolled cans
Use for
| Situation | Description |
|---|---|
|
|
Series of rolled cans created |
Limitations
-
The seam orientation of the rolled cans is dependent on the current work plane.
-
All rolled cans have the same diameter and thickness.
Selection order
-
Pick the first point.
-
Pick the second point.
The component is created automatically when you pick the second point.
-
To stop creating, press Esc.
Part identification key

| Description | |
|---|---|
|
1 |
Rolled can |
Picture tab
The Picture tab shows the points picked for the rolled cans.

Parameters tab
Use the Parameters tab to define the dimensions and position properties.
Dimensions

| Description | |
|---|---|
|
1 |
Diameter of the tubular profile All profiles are created with the same the diameter. You can modify the diameter of an individual can by changing the first value in the profile name in the beam properties. |
|
2 |
Wall thickness of cans You can modify the diameter of an individual can by changing the second value in the profile name in the beam properties. |
|
3 |
Angle between seam welds on adjacent cans You can modify the angle value by changing the rotation value in the beam properties. The default value is 180 degrees. |
|
4 |
Standard can length The component fits as many standard length cans between the picked points as possible, at the same time ensuring that cans shorter than the minimum length are not created. The standard length value is the maximum length of a can. Any non-standard length cans are positioned in the middle. To modify the length of cans individually after you have created the component, pick the point at one end of the can and drag it in the required direction and position to set the length. |
| Option | Description | Default |
|---|---|---|
|
Minimum can length |
Define the minimum length for a can. The component uses the minimum length value to determine a suitable series of can lengths to fit the defined distance. |
|
|
Assembly prefix |
Prefix for the assembly position number |
F |
|
Assembly start no |
Start number for the assembly position number |
1 |
|
Part pos prefix |
Prefix for the part position number |
C |
|
Part pos start no |
Start number for the part position number |
1 |
|
Material grade |
Define the material grade. |
|
|
Group |
Define the group. |
