Pasar al contenido principal

How scribing affects DSTV and drawing workflow

Tekla Structures - Not version-specific scribing numbering pop-mark
Not version-specific
Tekla Structures
Environment
Not environment-specific

Question
Something is unclear for me that I would like you to confirm. When using scribing in DSTV files, it will affect the numbering of the elements. Am I required to run DSTVs before I make drawings just to get correct numbers on elements?
E.g. common workflow:
1. Create element
2. Number
3. Create drawing
4. Create DSTVs [this affects numbering if scribing is on]
5. Drawing changes might have occurred

Scribing workflow?
1. Create element
2. Number
3. Create DSTVs [with scribing]
3. Number again?
4. Create drawings
Do I always need to run DSTVs before creating drawings and number multiple times to get the numbering correct? This is not intuitive in my opinion, but maybe Tekla Structures remembers that scribing is used once it has been set up?

Answer:
Tekla Structures does not read anything from the DSTV files when numbering or creating drawings, so basically the order does not matter, as long as the pop marks and scribing settings are fixed before the numbering and drawing creation. So it does not matter if the actual DSTV file exists or not, the the most important thing is that you have defined the settings in the NC Files dialog. Changing the pop-marking or contour marking settings is the same as changing the numbering settings. If you change numbering or scribing settings, the basic numbering command is typically not enough, but you need to use the Diagnose & Repair Numbering: All command, otherwise the settings are not recognized in numbering.

The following example shows how changing the pop-mark settings affects the numbering:

There are two otherwise identical beams but the other has site studs. No drawings in the first place.
1. Number the beams: Both get a part position b/1, because site studs are ignored if they are not pop-marked.

Image
Despite the site studs both beams have position b/1


2. Now in the NC file settings, select the Pop-marks option, then click the Pop-marks button, and define that you Add pop-mark centers of studs, save the settings, and close the dialogs, but do not create yet the DSTV files.

Image
In NC Files turn on pop-marks and select the add pop-marks to center of studs option


You get this warning:

Image
scribing_numbering_3.png


3. Number the model
         - If you run Number modified objects or Number series of selected objects numbering, both parts are still b/1
         - But if you run Diagnose & Repair numbering, another part gets different number: b/2

Image
End result after repair numbering, another beam gets b/2 position


4. Create the drawings and DSTV files.

So basically you need to fix the numbering and pop-marking and contour marking settings at the beginning of the project and must not change them during the project. This way it does not matter which you create first: drawings or DSTV files.

See also

NC files

Enviar

Table of Contents