Skip to main content

Part UDA Into Document manager (ML018)

Tekla Structures - Not version-specific
Not version-specific
Tekla Structures
Environment
Construsoft European

Image
thumbnail

 

System component Part UDA Into Document manager (ML018) can be used to write UDA's into the Document manager.

Back to top

Objects created

No objects are created.

Back to top

Use for

To write part (UDA) information into the Document manager.

Back to top

Before you start

Drawing should be available in the Document manager.
 

Back to top

Selection order

-

Back to top

Part identification key

-

 

General tab

Tab General can be used to define the available options. There are 8 identical "blocks" available.

Image
tab general

 

OPTIONDESCRIPTION
1

The available settings in the ConstrusoftEuropean environment:

  • cross section code in Document manager (used in Timber, cross section codes, create by tool Codes to profiles (ML052), see Tekla Warehouse).
  • profile into Document manager (standard setting, see example after this overview).
  • remove profile from Document manager (opposite of profile into Document manager).
  • standard (same as profile into Document manager).
  • UDA comment into Document manager (model UDA comment used in the model written into Document manager).
  • UDA USER_PHASE into Document manager (model UDA USER_PHASE used in the model written into Document manager, can be created by tool Write Numbering Results Into UDA (ML006).
2

The following options are available:

  • Part
  • Assembly
  • Project
  • User text
  • Advanced
  • No action
3Depending on the option chosen in option 2, several attributes can be chosen.
4Depending on the option chosen in option 3, this column will become available. 
5In this column you can define in which drawing UDA the information should be added. Note: make this drawing UDA visible in your Document manager. All information about the Document manager can be found here.
6

The data type needed, the options are:

  • String
  • Integer
  • Float
  • Option
  • Date
7In case in option 4 UDA is used: in which UDA should the information being written.
8

The available drawing types to apply the settings:

  • Assembly drawings
  • Single-part drawings
  • Cast unit drawings
  • General arrangement drawings
  • All types
9Press Write to run the tool. NOTE: you must select the drawing(s) first in the Document manager!

Example:
Use the setting profile into Document manager (1).
This option will write (main)part profile (2) into the Document manager. Drawing UDA used is: DR_MAINPARTPROFILE (4).
And since this is text, we use Data type: string (3).
 

Image
example 1
Image
example 2

 

About tab

Information about the "build" date of the tool. This date may differ from the date in the tool you are using, but the content may nevertheless be the same. This date may be required when you contact the helpdesk.

Image
tab about

All rights reserved. No conclusions can be associated to the representation of the pictures in relation to the operating systems under which Tekla Structures runs.

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International License. To view a copy of this license, visit http://creativecommons.org/licenses/by-nc-nd/4.0/ or send a letter to Creative Commons, 444 Castro Street, Suite 900, Mountain View, California, 94041, USA.

Back to top
Submit