Salta al contenuto principale

What is the difference between ULS Wind and SLS Wind?

Tekla Portal Frame Designer 18 uls wind sls wind
18
Tekla Portal Frame Designer
Environment
British Standard
ULS Wind uses coefficients from BS6399:2 Table 5 and should be used for all strength checks.
SLS Wind uses coefficients from BS6399:2 Table 5A and can be used for serviceability checks.

If you wish to use SLS wind (Table 5A) you should create a combination with ULS wind and select to perform just ULS checks, then create a matching combination with SLS wind and select to perform just SLS checks. Below is a suggested order of the steps to take to resolve problems with deflection under wind - note at any point you may decide to change you section sizes etc:

ULS Wind
ULS Wind + SLS Base Fixity
ULS Wind + SLS Base Fixity + SCI AD 277 combination factors
ULS Wind + SLS Base Fixity + SCI AD 277 combination factors + cl 2.1.3.6
SLS Wind
SLS Wind + SLS Base Fixity
SLS Wind + SLS Base Fixity + SCI AD 277 combination factors
SLS Wind + SLS Base Fixity + SCI AD 277 combination factors + cl 2.1.3.6

All this is discussed on our Portal Frame training course
Invia

Table of Contents