Przejdź do treści

How do I create a stair from an Architectural PDF?

Tekla Structures - Not version-specific Stair Workflow miscellaneous detailing
Not version-specific
Tekla Structures
Environment
Not environment-specific

The main thing with creating stairs is establishing the work point and nosing line of each flight of stairs going up. Most of the time the architect will supply you with a set of design drawings you can use as a guide.
 

Image
image.png

Steps:

1. Insert PDF of the floor plans of each stair landing up the building. When you insert the PDF into Tekla Structures, it will be converted to a DXF file and the DXF file will be inserted as a reference model. Use this link for more information on the insert PDF command.

 

 
Image
icon_tip.png

 
After the DXF file is created you can open this file and separate out the different views and clean them up to use on your E-Sheets.


2. For inserting the elevation of the stair tower, Create a new view at the location the architect cut their elevation. Change the work plane to this view and insert the pdf/dxf of the tower. When you are finished your model will look similar to what is shown below with the reference models you created.
 

Image
image.png

 

3. Update and adjust the grid and elevations to match the Architect grid and elevations. Reference this link to edit the grid properties.
4. Open a plan view looking down onto a stair plan.
5. Create a new view down the center of the flight of stairs.
 

Image
image.png


6. When the new view appears you will see the elevation that you inserted earlier.
 

Image
image.png


7. Use stair component to insert each flight of stair overlaying the pdf or using it as a guide.
8. Create a new view at the center of the far side flights stairs.
9. Use the stair command again to insert the stairs up the far side.
 

Image
icon_tip.png
If the flights of stairs are the same up the building you can copy the stair component to the different floors. You can also adjust the work points of each flight of stairs to make them match the architect drawings.

 

Image
image.png


8. Add landing headers and framing at each floor. connect landing to the wall as necessary.
9. Produce the elevation and plan drawings by creating a general arrangement drawing of the elevation views and plan views where you inserted the PDF/DXF reference models.
10 After the general arrangement drawing is created double click in the background to open the drawing properties.
11. Click the Reference Object button.
12. Make the reference files visible.
 

Image
image.png
Zachowaj

Table of Contents