Tekla PowerFab Silent Installation Guide
Install Tekla PowerFab automatically without any on-screen prompts using the Command Prompt.
Step 1: Open Command Prompt in the Correct Folder
First, you need to open the Command Prompt in the same folder where you saved the installer file (e.g., your Downloads folder). Here are two easy ways to do that:
Method A: From the File Explorer Address Bar (Easiest)
- Open File Explorer and go to the folder containing the
TeklaPowerFab[version].exefile. - Click in the address bar at the top.
- Type
cmdand press Enter.
Method B: Using the 'cd' Command
- Open the Command Prompt from your Start Menu.
- Type
cdfollowed by a space, then the path to your folder. - Press Enter.
For example, if your installer is in Downloads, the command would be:
cd C:\Users\YourUserName\Downloads
Tip: You can right-click the installer file while holding Shift and select "Copy as path". Paste this into the Command Prompt and delete the filename from the end to get the folder path easily.
Step 2: Run the Installation Command
Once the Command Prompt is open in the correct folder, you can run the commands below. In all examples, replace TeklaPowerFab[version].exe with the actual installer filename.
To Update an Existing Installation
The installer will automatically detect the existing installation. To update silently:
TeklaPowerFab[version].exe /S
/Stells the installer to run silently.
To Perform a New Installation
Client Installation (Default)
- In the default folder:
TeklaPowerFab[version].exe /S - In a custom folder:
TeklaPowerFab[version].exe /S /D=C:\CustomFolder
Server Installation
- In the default folder:
TeklaPowerFab[version].exe /S /INSTTYPE=Server - In a custom folder:
TeklaPowerFab[version].exe /S /INSTTYPE=Server /D=E:\ServerFiles
Important: The /D=[Directory] command must always be the last part of the command.