Slab Reinforcement Bottom
Not version-specific
Tekla Structures
Environment
Not environment-specific
The 'Slab Reinforcement Bottom' plugin allows you to create reinfocement in slab based on beams surrounded.
How to locate
Installers are available at 'Slab Reinforcement Bottom'.After installation, the 'Slab Reinforcement Bottom' plugin is available in the 'Applications & components'.
Image
Usage
Pick a slab,Pick main reference beam,
Pick remaining beams at other edges of slab and this selection is optional.
Slab Reinforcement Bottom dialog box
The dialog box contains the following tabs:Main Bars
Cross Bars
Properties
Main Bars
Image
Rebar length option:
| Type | Description |
| Coefficient | Rebar cover from beam center / slab edge is calculated based on factor of beam to beam / slab edge distance as shown dimension L1 in image. |
| Distance | Exact distance from beam center. |
Image
Change direction of Rebar:
This is yes / no control to control the direction of rebars and by default it created the rebar perpendicular to reference beam selected. If opted 'yes' then it rebar placed parallel to reference beam.
Range offset and spacing:
Range offset from beam face / slab edge are controlled as shown below. Bar spacing is target spacing and the spacing is maintained to this value or less than this value.Image
Cover Setout:
| Type | Description |
|
Image
| Cover from bottom of slab |
|
Image
| Cover from top of slab |
Cross Bars:
Image
Cross bar creation:
This is yes / no control to control creation of additional rebar along beam.Setout:
The cross bars are controlled as like main bars with coefficient / distance. Also range can be defined from beam face / slab edge.| Type | Description |
|
Image
| Places the cross bar below main bar |
|
Image
| Places the cross bar over main bar |
Properties:
All rebar properties are available in this tab.Image
Hook option:
Image
90 degree hook can be configured and to change the direction hook, enter negative value in leg length.