Skip to main content

Windbracing (1)

Tekla Structures 2021
2021
Tekla Structures

Connects a single hollow brace to a beam or column, using a connection plate, threaded rod, and nuts. Welds round plates to the connection plate and bolts it to the beam or column.

Warning:

Tekla Structures creates the threaded rod using the Detailing > Attach Part command. This means that the rod and brace are treated as a single part when you use commands like Delete, Move or Copy.

Profiles

Brace: RHS, tube

Parts created

  • Connection plate

  • Round plates (2)

  • Filler plate

  • Threaded rod

  • Nuts on rod (2)

Use for

Situation Description

Column or beam profile: H

Brace profile: RHS

Before you start

Create a beam or column and one brace.

Defining properties

Use the following tabs in the dialog box to define the properties of the parts this component creates:

Tab Contents See also

Picture

Dimensions that define the size and position of the connection and round plates.

Parts

Properties of all plates, nuts, and washers.

Defining part thickness (1)

Brace conn

Properties of the hole in the beam or column and the slot in the connection plate, position of round plates, rod dimensions.

Defining hole type (1)

General

Connection properties, AutoDefaults and AutoConnection rule groups.

General tab

Bolts

Bolt group properties for the bolts that fasten the connection plate to the beam or column.

Analysis

Information used in structural analysis.

Analysis tab

Selection order

  1. Beam or column

  2. Brace

Submit

Table of Contents