Skip to main content

Hollow Core Opening Tool

Tekla Structures 2021
2021
Tekla Structures

Hollow Core Opening Tool creates holes and recesses to hollow core slabs. Hollow Core Opening Tool works with single hollow core slabs, or with floors that are created with the Modeling of floor bay (66) modeling tool.

Objects created

  • Holes and recesses

Use for

Situation

Description

Hollow core slab with small and large openings

Limitations

Hollow Core Opening Tool calculates the location for the openings based on the given values and the slab profile data. If needed, you can use an external configuration file in XML format to provide different rules for the openings and the slab profile data.

You can define small and large openings. Small openings are placed in the middle of the hollow cores so that no webs are broken. Large openings break webs.

Before you start

Create a hollow core slab.

Selection order

  1. Select the main part (slab).

  2. Pick a position for the opening.

Hollow Core Opening Tool properties

Use the Hollow Core Opening Tool properties to control the properties of the openings and recesses.

Option

Description

Select the shape of the openings and recesses.

  • Square - in the middle of the slab

  • Round - in the middle of the slab

  • At one end of the slab

  • At both ends of the slab

Hollow positions

If you select to add openings or recesses at one end or at both ends of a slab, enter the positions of the hollows that are cut.

The positions are numbered from left to right at the start of the part. The part is viewed from the top in the start-to-end direction. The openings and recesses are created in the same voids at the end of the part.

Size

Define the size of the opening in longitudinal and cross direction, or the diameter for a round opening.

Opening width defines whether the opening is small or large.

Opening Type

Select the type of the opening.

Place exactly by point

Select whether the opening is created exactly to the picked position.

Centralize in zone

Select how the center of an opening is centered

  • By hollow:

    The opening is centered to the hollow core.

  • By web:

    The opening is centered to the web.

Cut full width of hollow

Select whether the opening is cut based on the minimum width of hollows or the number of hollows.

To use this option, center the opening By hollow in the Centralize in zone option.

Rules file (XML)

Select the external XML file where you have defined the opening and slab profiles.

Cutpart name

Define a name for the cut part.

Define the recess depth.

Define the alignment for the opening.

Select whether the thick side part of the opening is removed.

Configuration file example

Use an external .xml file to define the openings and the slab profiles.

Example

An example Zones.xml file is located in ..\ProgramData\Trimble\Tekla Structures\<version>\environments\common\system.

Submit

Table of Contents