Accept an invitation to hr.viewpoint.com, and set up a passkey (fingerprint, facial recognition, or PIN) for logging in.

1. Go to your email inbox, and look for an email from Viewpoint.

   

2. Open the email, and select Confirm Email and Configure Account.

   

3. The Set Up Your New Account page opens with your email address and name already populated. Select Next at the bottom of the page.

   

4. The Sign In page opens.

   If your username already exists, you can enter it, and select Next to sign in. You are now signed in and can skip the remaining instructions shown below.

   If your username does not already exist, select Create a Trimble ID, and continue with the steps below.

   
5. Select your region.

   

6. Enter your First Name and Last Name.

   

7. Read and agree to the terms of use.

   

8. Verify your identity:
   1. The system sends a verification code to your email address.

      

   2. The email comes from Trimble Identity. Locate that email in your inbox.
      Important: DO NOT use the Back button in your browser to go to your email. Instead, go to your home screen, and then go directly to your inbox.

      

9. Open the email, and copy the verification code.

   

10. Return to the home screen of your device, and re-open your browser (for example, Safari) to the Verify your identity page.

    

11. Paste the code you just copied into the Verification Code field.

    

12. Select Submit.

    This opens the password setup page.

13. Create a strong password that meets the requirements shown on the screen.

    

14. A passkey setup page opens. Select Create a passkey.
    Tip: A passkey can be a fingerprint, facial recognition, or PIN.

    

15. In the confirmation window, select Continue.

    

16. Log in with your passkey. For example, if you set up a PIN as a passkey, sign in with that PIN on your device.

    

17. Your passkey has been created. Select Done on the Passkey Created page.
18. The Account Preferences page opens. Choose your State or Province.

    

19. Select Next.

    Your setup is complete.