Channel cleat (8) connects two U-profile purlins to a column with an angle. The angle is bolted to the purlins and welded to a column flange.
Objects created
-
L profile
-
Bolts
-
Welds
Use for
| Situation | Description |
|---|---|
|
|
Two purlins connected to a column with an L profile |
Selection order
-
Select the main part.
-
Select the first secondary part.
-
Select the second secondary part.
-
Click the middle mouse button to create the connection.
Part identification key

| Description | |
|---|---|
|
1 |
L profile |
Picture tab
Use the Picture tab to define the gap between purlin ends.
Dimensions

| Description | Default | |
|---|---|---|
|
1 |
Define the gap between the purlin ends. |
20 mm |
Parts tab
Use the Parts tab to define the part properties.
Parts
| Option | Description | |
|---|---|---|
|
L profile |
Selec the profile from the profile catalog. |
L200-100-10 |
|
Option |
Description |
Default |
|---|---|---|
|
Pos_No |
Prefix and start number for the part position number. Some components have a second row of fields where you can enter the assembly position number. |
The default part start number is defined in the Components settings in . |
|
Material |
Material grade. |
The default material is defined in the Part material box in the Components settings in . |
|
Name |
Name that is shown in drawings and reports. |
Bolts
Use the Bolts dialog to define the bolt group dimensions and position, and bolt properties. You can also define the the bolt length increase, slotted holes, and how the bolts are staggered.
Bolt basic properties
|
Option |
Description |
Default |
|---|---|---|
|
Bolt size |
Bolt diameter. |
Available sizes are defined in the bolt assembly catalog. |
|
Bolt standard |
Bolt standard to be used inside the component. |
Available standards are defined in the bolt assembly catalog. |
|
Tolerance |
Gap between the bolt and the hole. |
|
|
Thread in mat |
Defines whether the thread may be within the bolted parts when bolts are used with a shaft. This has no effect when full-threaded bolts are used. |
Yes |
|
Site/Workshop |
Location where the bolts should be attached. |
Site |
Bolt assembly
The selected check boxes define which component objects (bolt, washers, and nuts) are used in the bolt assembly.
If you want to create a hole only, clear all the check boxes.
To modify the bolt assembly in an existing component, select the Effect in modify check box and click Modify.
General tab
Click the link below to find out more:
Design tab
Click the link below to find out more:
Analysis tab
Click the link below to find out more:
Welds
Click the link below to find out more:
